Dual lnb bracket setup

We carry a full line of all other manufacture Add to cart Andrews CPI 4. Add to cart Andrews CPI 5. C-band to Ku band adaptor. The OP will bolt directly to any standard C Band feed mount using 5. The OP will accept ma Will accept many different feed syst This feedhorn scalar ri This feedhorn sc Specifically for DirecTV.. Feed support arms and LNB arm. Replacement LNB Holder. Why install multiple satellite dishes when you can install a multiple LNB bracket?

Run cables between the dish antenna and the receiver s , leaving a service loop around the Mast Clamp 7. Using a peaking meter attached to the DPP Tighten all bolts see Table 1 and re-confirm maximum signal Note: The Connect the receiver cable s to the DPP Some restrictions apply when connecting Legacy receivers. Install additional receiver s , if necessary If applicable, connect a second satellite dish to the DPP Assembling and Mounting the Dish Follow these instructions to assemble the satellite dish, mount it, and point it in the direction of the satellites.

Note: If your skew angle is at the extreme ends of the scale greater than or less than 70 , insert nuts and bolts from the hardware pack into the additional skew holes. These additional skew holes provide greater stability to the dish at these extreme angles. See Figure 2. Installing the Receivers Use the steps below while referring to Figure 1. From the Point Dish screen, run Check Switch. On all other Legacy models, select Test. When the Check Switch procedure finishes, you should see an Installation Summary screen similar to the ones shown below.

Do not disturb the receiver during the process of downloading software. If exiting the Point Dish screen does not start the download process, turn off the receiver for at least 20 minutes on most receivers to allow the receiver to take a software download.

Run Check Switch again and confirm reception for all three satellites on all available satellite tuners. Your Installation Summary screen should be similar to the ones shown above in step 8. Some software on some models may identify the DPP This identification is OK. If installing an additional receiver, follow steps Welcome Sign In Register. Screw the other end to the coax input on the DiSEqC switch. Unscrew the coaxial cable from the coax input on the back of the satellite receiver.

Remove the cables connected to the satellite receiver. Remove the satellite receiver. Place the replacement satellite receiver that can switch the signal from the Dual LNB in the position now vacated. Connect the cables to the appropriate connections on the back of the replacement satellite receiver. Screw the coaxial cable into the coax input on the back of the receiver. Turn the receiver on from standby with its remote. Enter your zip code in the appropriate field to bring up a list of satellites.

Select two adjoining satellites from the list provided that correspond to your location.